No consigo controlar ventiladores con fancontrol

atk0110-acpi-0
Adapter: ACPI interface
Vcore Voltage: +0.83 V (min = +0.80 V, max = +1.60 V)
+3.3 Voltage: +3.28 V (min = +2.97 V, max = +3.63 V)
+5 Voltage: +5.04 V (min = +4.50 V, max = +5.50 V)
+12 Voltage: +12.15 V (min = +10.20 V, max = +13.80 V)
CPU FAN Speed: 2057 RPM (min = 600 RPM)
CHASSIS1 FAN Speed: 0 RPM (min = 600 RPM)
CHASSIS2 FAN Speed:1670 RPM (min = 600 RPM)
POWER FAN Speed: 0 RPM (min = 600 RPM)
CPU Temperature: +19.5°C (high = +60.0°C, crit = +95.0°C)

MB Temperature: +30.0°C (high = +45.0°C, crit = +95.0°C)

coretemp-isa-0000
Adapter: ISA adapter
Core 0: +34.0°C (high = +80.0°C, crit = +100.0°C)

coretemp-isa-0001
Adapter: ISA adapter
Core 1: +34.0°C (high = +80.0°C, crit = +100.0°C)

pwmconfig revision 5770 (2009-09-16)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.

We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.

/usr/sbin/pwmconfig: There are no pwm-capable sensor modules installed

Driver `w83627ehf':

• ISA bus, address 0x290
  Chip `Winbond W83667HG Super IO Sensors' (confidence: 9)

Driver `coretemp':

• Chip `Intel Core family thermal sensor' (confidence: 9)

To load everything that is needed, add this to /etc/modules:
#----cut here----

Chip drivers

coretemp
w83627ehf
#----cut here----
If you have some drivers built into your kernel, the list above will
contain too many modules. Skip the appropriate ones!